Easy as 123, Phase could be quickly integrated into your Rekordbox setup! 

There are actually two ways you can set up Phase with Rekordbox depending on your setup.
In this article you will find:  

👉How to set up using a DVS mixer 
👉How to set up using an analog mixer with Rekordbox Interface 2

Before getting into the explanation, let's talk about the basic requirements for using Phase no matter the DJ software:

Also, make sure that your mixer has the DVS mode enabled with your DJ software! 

If your current setup has all three above, let’s get started!

Set up Phase with DVS Mixer and Rekordbox

To make it simple, we'll use the Pioneer DJM-900 NXS2 mixer as an example, but rest assured, any DVS mixer compatible with Rekordbox can be set up in the same way! 

Now, let's get started with the step-by-step instructions:

1. Connect your Phase to a power supply (5V) using a USB cable.
2. Plug your Phase Receiver into your mixer's Line inputs via RCA. Choose either 1/2 or 2/3 based on your preference.
3. Connect the USB cable from your mixer to your laptop and set the Deck source selector on USB (A or B) to activate DVS Mode.
4. In Rekordbox, navigate to "Audio Settings" and select "DJM900-NXS2" as the Audio Interface.
5. Then, head to the "DVS" tab and make sure the DVS function is on. Choose "CDJs" instead of "Turntables" in the control hardware tab of the DVS settings.
6. Check that the audio routing matches your mixer decks (1/2 or 2/3) and set the virtual decks to "Relative" mode.
7. In the Phase Manager's "Setup" tab, select the "Rekordbox" DVS signal.
8. Now, place your Phase Magnetic Stickers and then Phase Remotes on top of your records and wait a few seconds for the calibration to complete before you start spinning.

After the steps, your setup should look like this:

And that’s it! You’re ready to rock with Phase and your Rekordbox setup!

Set up Phase with an Analog mixer and Rekordbox Interface 2 sound card

1. Connect Phase to a 5V power supply using a USB cable.
2. Plug the Phase Receiver into your sound card's Line inputs using RCA cables. Ensure that the switch on the sound card is set to "Line."
3. Connect the Rekordbox interface to your mixer's "Line" inputs and to your laptop via USB.
4. Open Rekordbox, go to "Audio Settings," and select "Interface 2" as the Audio Interface. Then, head to the "DVS" tab and ensure the DVS function is enabled.
5. Set the virtual decks in Rekordbox to "Relative" mode.
6. In the Phase Manager's "Setup" tab, select the "Rekordbox" DVS signal.
7. Place your Phase Magnetic Stickers and then the Remotes on top of your records and wait a few seconds for calibration to complete.

NOTE: Depending on your mixer, you may need to open the Setting utility to adjust the signal routing and select "Control Tone Line" as the input of your mixer.

And that’s it! You’re good to go. 👍

We hope this article has helped you set up Phase with Rekordbox quickly and easily.

And if anything, don’t hesitate to reach out to us if you still have any questions. 😉

Additionally, if you're curious about setting up Phase with other DJ software, don’t hesitate to check it out: Serato DJ Pro, Traktor, Virtual DJ, or even djay Pro AI! 

For more information or to discover and shop Phase, visit our website.